Car Dies When Put In Gear
Car Dies When Put In Gear. Up to $8 cash back if the map sensor is faulty, this foregoing sequence may explain why the engine dies as you put the vehicle into gear as a load is put on the motor. Just know it died in reverse, and was afraid to do more damage.
Ses came on right when this happened, throwing 0741 code. As itoaster said, it's possibly a locked torque converter. If it stalls like you pop the clutch, check the operation of the lockup torque converter.
It Has A 750 Holley Carb And A Unknown Aftermarket Cam.
Engine dies immediately when put in gear. Engine dies when put in gear motorcycle. It only cuts off when put in after starting it.i have to start it up,put in reverse then back to dr ,then its ok.
If It Stalls Like You Pop The Clutch, Check The Operation Of The Lockup Torque Converter.
Im at my witts end. If there is too much air in the engine, it would not work efficiently and would eventually shut off when you put it into gear. This could be caused by a vacuum leak, or possibly it is starving for fuel.
After The Motor Heats Up When I Put The Truck In Drive.
Started right back up no problem, but anytime i shift to anything but neutral the car stalls and dies. I dont think its a vacuum because all the vacuum lines are hooked up. If you can give it some extra gas and keep it running, check the idle air control valve.
I Haven't Had A Single Problem Until This.
Knowing that this particular vehicle has a multitude of vacuum hoses going to the carburetor, i would go with a vacuum leak 1st. You have to drain the transmission, pull it, replace the torque converter, bolt the transmission back onto the engine, and fill. It has to turn against the resistance of the torque converter because you are sitting still with the brakes applied.
This Could Lead To A Starting Car That Dies Right Away.
As for why it dies when its put it gear, there are several possibilities. If it idles and revs fine in park/neutral but dies in gear, i'd suspect a torque converter lock up solenoid. You can also unplug the wires that go to the transmission in the front.
Post a Comment for "Car Dies When Put In Gear"