Plastic Piece Under Car Dragging

Plastic Piece Under Car Dragging. Normally, an engine shield protects the engine compartment from hard objects outside. The size of these underside vehicle shields can range from something small (less than a square foot) to a shield that stretches the entire length of the car between the front.

under carriage plastic shield dragging 8th Generation Honda Civic Forum from www.8thcivic.com

Hi, i know little to nothing about cars so please excuse my ignorance. Well, that’s called a skid plate, and it’s there to protect your car’s underside from rocks, debris, and other hazards. Why is the plastic piece under car dragging?

Source: www.nissanversaforums.com

Have you ever noticed a plastic piece dragging under your car? Have it towed if possible.

Source: www.8thcivic.com

This is probably just a splash guard that came loose under the car and hitting or dragging. I would recomend inspecting the underside of your car and temporarily removing anything that is dragging/“falling off”.

Not A Big Deal To Drive Around Without It In The Short Term.

I removed the whole piece by undoing the screws around the edges (it was also secured by some plastic tabs but they slide out once the screws are. A few hours i reversed it over a broom and now the broom got stuck under it. The pic i took, with some annotations is from the driver side looking straight across with rear of car to right and front to left showing the loose.

I Tried To Drive Home And It Begin To Drag On The Ground.

Some automakers add a plastic strip to the bottom of the bumper on their cars. Location of oil pressure sensor for 2005 h2 hummer. For more info visit us at:

My Initial Attempts To Reattach With Cable Ties And Wire Did Not Last Long.

I also have a 2007 gti. It might be the plastic splash shield! Fri mar 22, 2013 2:01 am.

The Size Of These Underside Vehicle Shields Can Range From Something Small (Less Than A Square Foot) To A Shield That Stretches The Entire Length Of The Car Between The Front.

I would recomend inspecting the underside of your car and temporarily removing anything that is dragging/“falling off”. It might be the plastic splash shield! Skid plates are usually made of plastic or metal, and they’re attached to the underside of the car with bolts or screws.

Remove The Plastic Cover On Top Of The Engine.

Simply put the zip tie through one of the holes and attach it to an existing part on the car. The splash guard or splash pan, the plastic covering on the undercarriage of the car has come detached and is dragging from the bottom of the car. Take a look under for something big and plastic that looks out of place around the wheel wells and under the bumper.